Eleaf iCare Flask Kit Review

An interesting device, resembling an army flask, was released by Eleaf. This is the Pod System, called iCare Flask. The chip of the device is ease of use and quick delivery of nicotine into the body, incl. and saline .

vidmoda

Equipment

iCare Flask battery, iCare Flask Atomizer, magnetic 510 connector, manual, charging cable.

vidvape

Dimensions

Height: 71 mm; 
Width: 42 mm; 
Thickness: 12 mm; 
Weight: 69 g.

Battery pack overview

The mod is made of stainless steel and is available in two colors: gray and black. Mod implemented in the form of a curved jar with rounded edges. The capacity of the built-in battery is 540 mAh.

satom

Atomizer is inserted into a special compartment and is fixed on magnets. On the side panel is a LED charge indicator. Below is a USB port for charging the device. There are no buttons on the case – the mod works automatically when tightened.

Vape Starter Kit, Wholesale E Cig Starter Kits – AVE40

vidvappen

Block the device is also not possible. In general, the board has modern systems of protection against low charge, low resistance, short circuit and cut-off delay in 15 seconds.

Cartridge system

As an atomizer in the whale is a small tank with replaceable ceramic evaporators. Above is a metal driptip. Additionally, it is the top cover of the filling. The diameter of the hole is small, so it is recommended to use suitable bottles with thin noses.

vidvappor

The flask is held on the bottom of the oring, pressed on top of the top cap. The volume of the tank was 1 ml, which is quite impressive for such sizes. Ceramic resistors of 1 Ohm are used as evaporators. No tightening adjustment – air is drawn from one small hole at the bottom of the tank. Atomizer has a standard 510 connector. To work with this whale, the tank is wound on a special magnetic spacer, which is then attached to the fashion. We found a similar system in the Eleaf iStick Basic Kit.

Who needs iCare Flask

The whale turned out to be a rather peculiar answer to modern POD systems. iCare Flask can be called the ideological successor of the iStick Basic Kit. The same implementation of the mod in the form of a stick and the use of a small tank on removable evaporators with a magnetic connector. A small air intake opening will allow you to get tight traction that is suitable for MTL lovers or beginners. Refueling is quite convenient, firing and unhygienic, as it is necessary to remove the top cover-drip tip for refueling.

vidnaego

The fluid level is quite easy to track due to the slot on the side of the mod. The battery capacity is only 520 mAh, so the charge will be enough for a maximum of the day of use. The board is as simple as possible in operation; actuation occurs upon tightening. Since the diameter of the mounting hole for the atomizer is still unknown, the question of using serviced atomizers remains open. Therefore, this bundle can be considered as the same POD system. Therefore, it is suitable for lovers of compact bundles and novice bathers.

Click Here Ave40  For Vape Wholesale Cooperation.

Now It’s Available: Eleaf iCare Flask Kit
Hot Sale Recommendation:

Vaporesso Aurora Play Zippo Pod Starter Kit

Dovpo Topside Dual Squonk Box Mod

Voopoo Alpha Zip TC Kit

Voopoo Drag Nano Kit

Vaporesso Luxe 220W TC Kit

Vape Wholesale & buy Electronic Cigarettes online in Bulk. Quality Vape Products, Trusted Vape Wholesale Supply by VapeShops Owners.

WHOLESALE INQUIRY: https://www.ave40.com/wholesale-service.html

Eleaf iStick Mix Starter Kit Review

Eleaf has released the iStick Mix Kit. The “epoxy” kit was assembled from a 160-watt two-battery box-mod box and an unattended Ello Pop tank with a rubberized bulb.

    The boxmod was packed in a rectangular case with rounded corners and a convex silhouette. The ends trimmed polymer panels that combine different patterns and patterns, in the palette of colors included five variations. A familiar set was placed on a narrow front side – a round fire button, a monochrome display and two control keys. USB port installed on the side. Batteries hidden under one of the removable sidewalls. 

   The branded Avatar Chip card supports varivatt, thermal control, bypass and several memory modes. Output power can reach 160 watts. Resistance ranges from 0.05 to 3.0 ohms. Two 18650 batteries are used for power supply. When charging via USB, you can use up to 2.5A current. 

Ecig Wholesale China,e Cigarette Online Shop – AVE40

   The body of the complete tank Ello Pop is made of stainless steel and is completed with an “epoxy” drip tip in the fashion color. The filling hole is under a massive firebox with protection from playful children’s hands. Glasses of plump flasks are surrounded by thin rubber rings. There is a rotating ring blowing with wide notches.

Atomizer ELLO POP

 The ELLO atomizer has been used by Eleaf more than once in its starter kits, but the manufacturer began to use the ELLO POP – an updated version. To say that it is fundamentally different from the previous version is difficult, because one of the glasses has been modified (there are rubber bands on it for protection) and a slightly modified design. 

The atomizer works on quite interesting evaporators of the HW-M2 and N2 series, which work on a grid, and they use a grid with different cells. It is worth saying that such evaporators will please the vapers with their taste transfer and bulk – the grid will make itself felt.

Top Vape Tanks, Vape Atomizer, Clearomizer Online | Ave40

Features Of Eleaf iStick Mix Starter Kit 160W with ELLO POP Atomizer 6.5ml/2ml

Parameters

Eleaf iStick Mix MOD
Size: 52 x 27 x 83mm
Battery type: Dual 18650 batteries (not included)
Output wattage: 160W max
Resistance range: 0.05-3.0ohm
Output voltage: 0.5V-9V
Thread: 510

ELLO POP
Diameter: 28mm(6.5ml)/26.5mm(2ml)
Height: 56.5mm
E-liquid capacity: 6.5ml/2ml
Coil: HW-M2 0.2ohm Head (kanthal, 40-90W)
HW-N2 0.2ohm Head (kanthal, 40-90W)
Thread: 510 thread

Eleaf iStick Mix 160W Kit with ELLO POP Atomizer

Features:

Dual 18650 Cells with 160W Output
Artistic Double-sided Resin Panels
Steady and Efficient Recharging
Distinctive in Molding Label(IML) Technology
Avatar Chip for Stable and Fast Fire Speed
New HW-M2 / HW-N2 Coils with LPSC Technology
Innovative Bodyguard on the 6.5ml Glass Tube
Easy Slide Top Filling & Adjustable Bottom Airflow Control
Smart Child-proof Structure

Package List:

It comes with

  • 1× iStick MIX MOD(without cell)
  • 1× ELLO POP Atomizer 6.5ml/2ml
  • 1× HW-M2 0.2ohm head
  • 1× HW-N2 0.2ohm head
  • 1× QC3.0 USB Cable
  • 2× User Manuals
  • Spare Parts

Eleaf iStick Mix 160W Kit with ELLO POP Atomizer

Click Here Ave40  For Vape Wholesale Cooperation.

Now It’s Available:Eleaf iStick Mix Starter Kit
Hot Sale Recommendation:

Vaporesso Aurora Play Zippo Pod Starter Kit

Voopoo Alpha Zip TC Kit

Vaporesso Luxe 220W TC Kit

Voopoo Drag Nano Kit

OUMIER Armadillo RDA

Vape Wholesale & buy Electronic Cigarettes online in Bulk. Quality Vape Products, Trusted Vape Wholesale Supply by VapeShops Owners.

WHOLESALE INQUIRY: https://www.ave40.com/wholesale-service.html